Substrate Compatibility
Can I Use Fauxbroidery Transfers on 100% Rayon / Viscose?
Fauxbroidery on rayon requires maximum care. The puff layer needs heat to activate but rayon's scorch point limits temperature to 285-295F, resulting in a subtler dimensional effect. Pressing pressure must remain very light to avoid permanent fabric marks.
Why This Works
Press at 280-290F with very light pressure. Use a pressing pillow. The fauxbroidery texture will be less raised than on cotton. Cold peel is required. This is considered a specialty/premium application where customer approval on a sample is recommended before production.
Press Settings
| Setting | Value |
|---|---|
| Temperature | 270-295F (132-146C) |
| Press Time | 10-15 seconds |
| Pressure | Light-Medium |
| Peel Method | Cold Peel (30-90 seconds) |
| Pre-Press | 270-285F, 3-5 seconds |
| Finish Press | 270-285F, 5-8 seconds |
| Dye Migration Risk | moderate |
Common Mistakes to Avoid
- Rayon is extremely heat-sensitive. Exceeding 295F can cause permanent scorching, fiber damage, and sheen changes.
- Too much pressure leaves permanent press marks — rayon does not recover from compression.
- Rayon can shrink under heat. Do not over-press.
- Some rayon dyes are reactive. Test on an inconspicuous area first.
Pro Tips for This Combination
- Cold peel is safest for rayon. Let the transfer cool completely (60+ seconds) before peeling.
- If adhesion feels weak at 270F, increase time by 2-3 seconds rather than raising temperature.
- Use a pressing pillow inside the garment to prevent press marks and ensure even pressure.
- Rayon DTF transfers are achievable but require the most careful handling of any common fabric.
Pre-Press Step
Gentle pre-press only. Rayon scorches easily. Keep pre-press under 5 seconds.
Finish Press Step
Use Teflon sheet. Very light pressure. Rayon shows press marks easily.
Get Fauxbroidery Transfers from Long Island DTF Printing
Ready to try Fauxbroidery Transfers on 100% Rayon / Viscose? Order samples first to test before committing to a production run.
For the complete press settings guide for this fabric type, see: Fauxbroidery Transfers Press Settings for 100% Rayon / Viscose
Frequently Asked Questions
What temperature do I use for Fauxbroidery on 100% Rayon / Viscose?
Press at 270-295F (132-146C) for 10-15 seconds with light-medium pressure. Press at 280-290F with very light pressure. Use a pressing pillow. The fauxbroidery texture will be less raised than on cotton. Cold peel is required. This is considered a specialty/premium application where customer approval on a sample is recommended before production.
Hot peel or cold peel for Fauxbroidery on 100% Rayon / Viscose?
Use cold peel for this combination. Wait 30-60 seconds after pressing before peeling to allow the adhesive to cool and bond fully.
Do I need to pre-press 100% Rayon / Viscose before applying Fauxbroidery?
Yes. Pre-press at 270-285F for 3-5 seconds. Gentle pre-press only. Rayon scorches easily. Keep pre-press under 5 seconds.
How long does a Fauxbroidery transfer last on 100% Rayon / Viscose?
Due to the limited compatibility of Fauxbroidery on 100% Rayon / Viscose, wash durability may be shorter than standard. Test wash on a sample before committing to production.